67mm should also be stenciled on the front edge of the lens somewhere. If so, then you should be good to go. It should be on the lens because a lens cap can be lost or broken. 

Unfortunately this is for adapting lenses to Olympus' modern digital Micro 4/3 cameras. It won't work with the Pen FT or similar half-frame film cameras, and you most likely won't find anyone making adapters for these. 

Yes 

FD-EOS fit for Canon FD mount lens and canon EF mount camera body. canon 60d is EF mount, so the adapter ring can work with your camera, but you need to check your lens mount. could you pls let us know your lens specific model? service(AT)kentfaith(DO NOT)com, Please note: It is not same between Canon FD mount and EF mount, this adapter ring is only for Canon FD mount lens, please contact us if you want to purchase for Canon EF mount lens. 

1. If there is ever any more than a slight amount of rotational play, you may want to try tightening the lens mount adapter so it will hold the lens tighter to the mount. There are 3 flanges in the middle of the adapter (what the lens locks onto) that are split open slightly, this gap is what gives the tension that holds the lens tight to the body. Over time and with use these gaps decrease in size, no longer pulling the lens tight to the adapter, which allows the lens to move inside the mount more than it should.
2. To tighten the fit, get a slim metal object (a #1.5 or #2.0 small flat eyeglass screwdriver is ideal) and insert it into the slit to open it up just a little bit (see images below, make sure to do it to all 3 evenly). The more you open the gap, the tighter the lens will be to the adapter; too much and the lens will have a hard time mounting so make sure to do it just a little bit at a time to all 3 flanges evenly, it doesn’t take much at all to get a tight fit.Note: please do not use too much strength, or the shrapnel will be damaged.