We installed it on our Canon RF 24-105 lens and it was possible to use the lens hood on this lens because the lens hood attaches to the lens via the bayonette mount which is on the outside of the lens diameter and the magnetic filter adapter screws into the thread on the inside of the lens. 

The adapter for a EOS body to a Canon FD manual is the adapter needed. The Canon AE1 uses the FD/FL lens mount. The one I purchased works without a hitch. Mine is a K&F Concept Pro lens mount for Canon FD, FL lenses. From a F1 to a 5D Mark 4 with no issue. 

I have the 77mm version of this and I am NOT able to use a lens hood on my Canon 17-40mm wide angle once the filter is on. I haven't tried putting on the hood first and then trying to screw on the filter yet. That's not to say that all lens hoods won't work but for me it does not under the scenario described above. 

FD-EOS fit for Canon FD mount lens and canon EF mount camera body. canon 60d is EF mount, so the adapter ring can work with your camera, but you need to check your lens mount. could you pls let us know your lens specific model? service(AT)kentfaith(DO NOT)com, Please note: It is not same between Canon FD mount and EF mount, this adapter ring is only for Canon FD mount lens, please contact us if you want to purchase for Canon EF mount lens. 

There are two types of FD mounts
FD/FL Breech-Mount (with a silver ring, you need to rotate the silver ring when attachment and removal), breech-lock mounts are identified by the silver ring
New-FD Bayonet Mount, bayonet mounts are identified by a red dot next to the lens release button

Here are the steps to install breech-mount version

1. Set your lens to smallest except for auto(bayonet mount only)
2. Rotating the Lock-Open ring of the adapter on the OPEN side
3. Line up the red dot with your lens and adapter ring(if yours is bayonet mount, just turn the adapter ring towards clockwise direction to make lens and adapter tight,then ignore the 4th step)
4. Turn your lens ring towards counterclockwise direction to make the adapter ring tight with your lens
5. Rotating the Lock-Open ring of the adapter on the LOCK side to engage the aperture closing pin

Operating the adapter

1. If you'd like to operate the lens aperture with the adapter; on your lens, set the aperture to the smallest opening and use the adapter ring
2. If you'd like to operate the lens aperture with the lens; place the adapter ring on the small aperture(Lock place) and control the aperture on the lens