Lens Mount Adapter Rings

If there is ever any more than a slight amount of rotational play, you may want to try tightening the lens mount adapter so it will hold the lens tighter to the mount. There are 3 flanges in the middle of the adapter (what the lens locks onto) that are split open slightly, this gap is what gives the tension that holds the lens tight to the body. Over time and with use these gaps decrease in size, no longer pulling the lens tight to the adapter, which allows the lens to move inside the mount more than it should.
To tighten the fit, get a slim metal object (a #1.5 or #2.0 small flat eyeglass screwdriver is ideal) and insert it into the slit to open it up just a little bit (see images below, make sure to do it to all 3 evenly). The more you open the gap, the tighter the lens will be to the adapter; too much and the lens will have a hard time mounting so make sure to do it just a little bit at a time to all 3 flanges evenly, it doesn’t take much at all to get a tight fit.Note: please do not use too much strength, or the shrapnel will be damaged.

how does it attach to the camera? Do I need anything other then whats included for them to work on a nikon d7200?

The kit comes with 9 adapter rings for all sorts of lens sizes. You screw the adapter onto your lens, then the square piece screws onto the adapter and the filters slide into the square piece. The lens sizes the adapters fit are 49 mm, 52 mm, 55 mm, 58 mm, 62 mm, 67 mm, 72 mm, 77 mm and 82 mm. It matters more of the lens size than the camera you are using. Have fun with them!!

Can this work with Sony a6400?

Hi, what's your lens size ,this square filter set with 8 adapter rings can fit lens size from 49mm to 82mm, if your lens in this range , it would be ok, thanks.

Log Into Your Account

Login

Register Account