What is there to say? Nikon is always nikon, reliable and great flash.

I’m a First Responder that has an account with FirstNet. FirstNet is built by AT&T for First Responders. I called Weboost and was told that Weboost is not compatible with my FirstNet service because it runs on Band 14, which is not compatible with Weboost. She mentioned that the FCC does not allow signal boosters on the Band that FirstNet uses. Major bummer!

This 4G camera works as advertised, and I am very satisfied with the purchase. I did have an initial problem with the AT&T network not sending the mms and txt emails to my phone via messaging, and it turned out to be an AT&T issue, not a camera issue. I contacted Creative-XP, and they helped with troubleshooting. The problem was that AT&T routinely disables emails-to-text features due to spammers abusing it. If you have trouble receiving photos from this camera via messaging, call AT&T and ask for upper level support. Ask them to enable email-to-text.Awesome camera so far.

This is the third one I ordered. The first two would only connect from my home network and would not connect thru AT&T. This one works great, at least so far

I love this mount. It is not compatible with the Nikon FTZ adapter unless you move it from the body to the adapter or buy another mount just for the adapter. I’ve hike a couple mountains and bustled through crowds without fail using this mount.

This connected to my AT&T router and boosted the internet

Part 1 - Minolta MD to Sony NEX adapterTechnically, it slightly overshoots infinity but the issue is easily corrected by dialing back the focus ring just a tad --- Not exact but clearly better than not-at-all.Although very light due to extensive aluminum usage, the build quality and fit-and-finish of the adapter is superb. Connections on the lens and camera mount sides are tight and precise --- absolutely, zero slop. The top of the lens release button is flattened making the lens removal process very easy and comfortable.Other notes:- There are no electrical connections so focus and zoom must be done manually on the lens itself- When mounting the lens, turn the adapter clockwise till you hear a "click"- Tested with a Minolta 85mm f/1.7 Rokkor-X MD lens mounted to a Sony a6000 camera-----------------------Part 2 - Nikon Ai to Sony NEX adapterEdit: Based on my positive experience with the Minolta MD adapter, I also purchased the Nikon Ai adapter later.As with the Minolta MD adapter, the Nikon Ai version focuses beyond infinity a tiny bit. Fortunately, the same solution applies - dial back the focus ring and the horizon will become crystal clear. The build quality is impeccable and the finish is smooth and clean of burrs or machine marks. Connections on both sides are taut and precise with zero play.Additional notes for Nikon Ai adapter:- No electrical connections present so focus and zoom must be done manually on the lens.- Unlike the Minolta MD adapter, mounting the lens for Nikon adapter requires a counter-clockwise turn until you hear the "click" of the locking mechanism- Tested with a Nikon Micro Nikkor 55m f/2.8 Ai-S MF lens mounted to a Sony a6000 camera

AT&TI got this to use on my long trips around the country with my trailer. Had to do a few modifications to the base kit but it worked out.We connected the main antenna to our trailer but also have the option of hooking up a shark fin style antenna on our vehicle for when the trailer is not connected. I ran the extension wire through the rubber grommets in the back of my car and then snaked the rest of it behind my trunk lining until it reached the rear seat bench where I set up the booster. The booster tends to get a little hot even in the air conditioned car so I strongly suggest installing it in the vehicle if possible.The mods:- a 9ft SMB cable extension so I can run a detachable setup (for when the trailer is decoupled and the amp stays in the vehicle - sedan),- 2 marine waterproof fuse cases (yellow rubber) so I can protect the coax SMB ends when disconnected and/or connected.After connecting it and powering it on, while stationary I got a boost in bars from 1,2 to 4,5 and a significant increase in download and upload speeds. I found that this booster really improves the upload, in some cases it gets high as the DL which I've never seen happen during normal daily use even when next to a cell tower.The only negative aspect I've discovered is signal issues when getting close to a cell tower. We were driving north on I95 and whenever we got withing 1/2 mile of a tower our DL speeds would plummet to less than 1 mb/s even though signal strength was still maxed out at 5 bars. If we turned off the booster we'd get an immediate speed bump to the normal AT&T standards on 4G LTE (~35 mb/s).Similarly, driving around towns with the booster powered on we experienced loss of signal (goes from 5 to 3 bars), increased lag (ping in the upper 100s milliseconds) ms and overheating of the booster housing.Overall this is a great system as long as you are not in the vicinity of a cell tower. If withing 1 mile or less it's better to just turn it off.