Ricoh Kr-5 Super Lens Mount
Related Product
4K 32MP tracking hunting camera, 100° wide-angle motion sensor triggering in 0.2 seconds, 46pcs 940nm low-light LED lights, IP67 waterproof with 2.31-inch display
Prime Day
Prime Day
4K 32MP tracking hunting camera, 100° wide-angle motion sensor triggering in 0.2 seconds, 46pcs 940nm low-light LED lights, IP67 waterproof with 2.31-inch display
$89.99
Related Faq
Q
I am going to Europe in September. What power adapter can I use to charge these batteries?
A
Any USB charger will do. As long as it accepts European voltages, your phone charger will work. Super handy if you want to charge while driving. 
Q
Is there a lens cap that works with these adapter rings?
A
I doubt it: not because of their diameter, but because they are super- slim so no obvious place for a lens cap to attach to. This said, they screw on and off with minimal effort, so I take them (and the filter system off) off before transporting the camera to a new location. 
Q
Will this work on my sony a6000 and tokina minolta 100-300mm macro zoom?
A
Yes 
Q
Too loose/there is gap between lens and adapter ring
A
  1. If there is ever any more than a slight amount of rotational play, you may want to try tightening the lens mount adapter so it will hold the lens tighter to the mount. There are 3 flanges in the middle of the adapter (what the lens locks onto) that are split open slightly, this gap is what gives the tension that holds the lens tight to the body. Over time and with use these gaps decrease in size, no longer pulling the lens tight to the adapter, which allows the lens to move inside the mount more than it should.
  2. To tighten the fit, get a slim metal object (a #1.5 or #2.0 small flat eyeglass screwdriver is ideal) and insert it into the slit to open it up just a little bit (see images below, make sure to do it to all 3 evenly). The more you open the gap, the tighter the lens will be to the adapter; too much and the lens will have a hard time mounting so make sure to do it just a little bit at a time to all 3 flanges evenly, it doesn’t take much at all to get a tight fit.Note: please do not use too much strength, or the shrapnel will be damaged.
 
Q
What kind of rear and front caps would I buy to go on this since it doesn't come with any?
A
I don't think you need any. There is no glass. 
Related Video
K&F Concept® Lens Mount Adapter for Canon EOS EF mount Lens to GH4
K&F M10101 M42 Lenses to Sony E Lens Mount Adapter
K&F M10111 M42 Lenses to Fuji X Lens Mount Adapter
Related Blog

Ricoh Kr 10 Lens Mount Ricoh Kr 5 Lens Mount Ricoh C Mount Lens Canon Lp V Mount Pentax Kr Lens Mount Ricoh K Mount Lens Ricoh Kr 30sp Lens Mount Ricoh Kr-10 Super Lens Mount Ricoh P Lens Mount Kr Mount To Nikon

Canon Fd To Nikon Adapter T Ring Adapter Nikon Sony A7rii Canon Adapter Sony Rx100 Iii Filter Adapter Conversion Lens Adapter Hood Kit Lah-dc20 70x200 F Mount Lens Pentax K Mount Cosina 100 400mm Lens T Mount Lens Pentax M42 Adapter Nikon Dslr Ef Adapter For Sony F5