I was very shocked how amazing this was! Everyone get one!!

use it for all my adventures when going for travelling! bought two extra batteries because it does not last more than two hours

These were inexpensive and they do the job I wanted them to do.

Has everything I could possible need to mount for any situation so far. Might buy a back-up in case I happen to misplace my case.

Bright lights...little wobbly but good enough for what I need.

I had previously bought a phone holder that grabbed your phone when placed in the holder. It was a nice feature, but removing the phone was not as pleasant. Got this one and all you need to do is clamp down on the wings to grab it. To release just pushed the button on the back. The included hardware makes it easy to install. If this one ever fails, I'll just get the same one.

Just got a new laptop and alway need more connections. This thing does the trick and more some. Very happy.

Bought this for a Christmas gift for my 10 year old nephew. After installing it he really loves it. Now I do recommend one thing. Have a plan before installing it. Know how many feet you need and get a game plan worked out. Do not just think your going to throw it up on the wall and it will look nice. It doesn't work like that. The key to these lights is that they are indirect lighting. You do not what to be looking at them. They may not seem like it but they are very bright. if you just throw them up on your walls your going to be kicking yourself later.I tried to do this on the cheap so what I did was go to lowe's and bought: EverTrue Craftsman 3/4-in x 8-ft Unfinished Vinyl Cove Moulding. $4/eachA box of white finishing nailsTwo gorilla double sided tape(You also need a hammer, hacksaw, scissors, drill with a paddle bit or hole saw.)Don't bother with a level. What you want is a spacer. I did mine about 1 1/2 inches from the ceiling. You just need to run the spacer from the ceiling to the top of the moulding.Long story short I ran the moulding around the room about 1 1/2 inches down from the ceiling. I didn't want to see the wires in the bed room and the room next to it had my computer router so I just drilled through and ran the power supply that way. I cut tape stripes about 1-3 inches long and placed them every foot or so on top of the moulding. I then ran the LED lighting around the room leaving the factory tape on so that if he ever wanted to take the led lighting off he could with no hassle in the future. Make sure you cut on the dotted lines on the LED strip. Also do it with the power off.