Reviews
It works OK..
When you screw a m42 lens into a m42 camera mount, the red dot stops top dead centre, with the adapter to a fuji camera it goes about 5 deg. past. "No big deal"..
30/05/2019
Related Reviews
what a design, more than what you see
excellent, I did not expect a 3/8" female screw, a 2nd mount can be attached too.
18/04/2022
Good product needs a little work
I was only able to put 2 screws in a 4 screw mount did not match my holes
17/02/2022
Durability..
Light and easy to mount camera but,,, I recieved 2 when I ordered 1 and was missing mounting screw otherwise good..
03/10/2021
easy to put on my bike
Works perfectly for what I ordered it for. Clamps tight, easy to put on my bike, and the screw mount works great.
03/09/2021
Easy to Install!
Everything is included for smooth and very easy installation! Includes screws for wall mount, small screw driver to tighten lighting mount. Look forward to illuminating my patio plants!
24/06/2021
Not great, but not bad either
Not great, but not bad either. It is cast aluminum, so it's fairly durable. The set screw for the umbrella is very difficult to tighten by hand. Comes with a 1/4 bolt on top plus a cold shoe adapter. And it comes with a threaded adapter in case you don't have a light stand.
27/04/2021
The Brio Rocks
Works perfectly with windows hello even in low light environments. It has a screw mount under the monitor mount for an array of additional attachments. Great product!
15/03/2021
Decent stand - doesn’t support JBL 9.1 true wirele
Following up on another review for support for JBL 9.1. The other review helped but I had to trial and error. The mount that comes with the JBL satellites will fit through the circular hole on the horizontal bracket that you attach to the L bracket. HOWEVER, the L bracket obscures the hole JUST ENOUGH to make it annoying. No, this kit does not include everything to mount them. Also, If the L bracket was a tiny bit narrower, this would be much easier but you need a slightly narrower fastener on that side.Here’s what you need:2x - M5 - 0.8mm Cap Nuts2x - M4 - 0.7mm Cap Nuts2x - M5 - 0.8 x 16mm Flat Head Machine Screw2x - M4 - 0.7 x 20mm Flat Head Machine Screw4x - M4 Flat WashersOptional:2x - 5mm Flat WashersSee my picture. You have to use two washers on the circular hole of the horizontal bracket to make it flush when tightening the screw cap.
17/02/2021
Related Articles
Top Bestselling Products
-27%
-35%
-9%
Products You May Like
Blog You May Like
